Für eine erfolgreiche Anwendung empfehlen wir dir dringend, dich an die Anleitung und die einzelnen Schritte des Videos zu halten. Damit du mögliche Fehler vermeidest und deine Anwendung reibungslos funktioniert, schaue auch gerne unten in unserem FAQ Bereich vorbei. Erstanwendern empfehlen wir, sich an die Videoanleitung zu halten.
Our Magic Stripes are small eyelid stickers that conceal drooping eyelids in seconds without surgery.
The strips are moistened with water on the back and then stuck to the upper eyelid crease. The sticker thus pushes the eyelid crease upwards with every blink of the eye and thus conceals the drooping eyelids.
Our Magic stripes last up to 12h, if they are glued correctly, and even while sleeping!
No. A new sticker should be used with each application.
The more severe the drooping eyelids, the larger the Magic Stripes size. If you're not sure, we have an extra Mix Box with all the Stripes sizes so you can try them all and find the perfect Stripes for you!
The Magic Stripes should be stuck on the end over the eye shadow or other make up, otherwise they will be visible through the fine powder or similar. The Stripes adapt to any color.
The Stripes are only stickable on the smooth back side, the other side is texture (front side). Only the gel side (the side that attaches the strips to the paper) is sticky.
The adhesive on the back side is activated by applying the water. Since the stickers should be generously moistened with water, it is therefore very important to dab off the excess water after sticking them to the eyelid with a tissue or similar (Not with your finger!), dry for at least 2 minutes, and keep your eyes closed!
In case there are adhesive residues from applying on the eyelid, we advise you to remove the sticker, clean the eyelid once with water, dry it and use a new sticker.
The strips need to be moistened very well to make them stick properly.
Also note that only the smooth back side is stickable!
If a sticker should peel off easily at the ends, it was just not moistened and/or pressed on well enough during application. It is best to use the included tweezers, moisten them slightly at the tip, then apply the water again under the sticker and press it lightly with the tweezers. Allow to dry briefly and you're done.